PL200 KIT includes two of the Power Line Adapters that allows users to turn their home’s wiring into a network just by plugging them into available wall outlets. It provides high speed data rate up to 200Mbps and coverage range up to 300 meters that won’t get any influence from obstacles. So it is applicable to a large area of housing and Small Enterprises Office area etc, providing simple and convenient, no radiation, scalable network solutions.
No Wires, Easy-to-Setup
With PL200 KIT working together, no wires are needed to extend your network throughout your house, more convenient and flexible deployment.
HomePlug AV Ethernet Bridge
High-speed Internet access can be easily achieved for your house by HomePlug AV Ethernet Bridge. By pressing the SEC/Rst button correctly, you can share the same electrical lines to other HomePlug AV Ethernet bridges.
- Complies with Home Plug AV, IEEE 802.3 and IEEE 802.3u standards.
- High-speed data rate up to 200Mbps.
- Super small design with detachable power plug.
- No need cables, using electrical wires.
- Up to 300 meters range, excellent solution for wall and floor crossing.
- Plug and Play, no configuration required.
- Green product, power consumption reducing up to 65%.
- Built-in QoS assures the quality of bandwidth sensitive applications such as voice, video and online games.
Hardware | |
|---|---|
| Interface | -1*10/100Mbps Ethernet Port |
| Power Supply | - AC 100V~240V |
Dimensions |
- 93mm x 56mm x 30mm（L x W x H) |
| LED Indicators | - 1*Power, 1*LAN |
Standards |
- HomePlug AV, IEEE 802.3, IEEE 802.3u |
Data Rate |
- 200Mbps over Powerline |
Modulation Type |
- OFDM/CCK/16-QAM/64-QAM |
Power Consumption |
<4w |
Environment |
- Operating Temperature: 0℃~40℃ (32℉~104℉) - Storage Temperature: -40~70℃ (-40℉~158℉) - Operating Humidity: 10%~90% non-condensing - Storage Humidity: 5%~95% non-condensing |
It is suitable for: PL200, PLW350 |
No matter how far it is, PLCs can connect to each one only if they are in the same loop of circuit.
It is suitable for: PL200, PLW350 |
Maximum 8 PLCs are allowed to pair with synchronously.
It is suitable for: PL200, PLW350 |
Application : You can connect a number of devices on a powerline network, but you can only use the pair button on two devices at a time. We suppose that the Powerline adapter that connected with the Router is adapter A, and that connected with the computer is adapter B.
Please follow the below steps to create a secured Powerline network using the pair button:
STEP-1:
Press the pair button of Powerline adapter A for about 3 seconds, the Power LED will start flashing.
STEP-2:
Press the pair button of Powerline adapter B for about 3 seconds, the Power LED will start flashing.
Note:This must be done within 2 seconds after pressing the pair button of powerline adapter A.
STEP-3:
Wait for about 3 seconds while your Powerline adapter A and B are connecting. The Power LED on both adapters will stop flashing and become solid light when the connection is made.
|
It is suitable for: PL200, PLW350 |
Press and hold Sec/Rst button for about 10 seconds, the device will reset to factory settings and reboot again.
