Application introduction
Repeater Mode, you can extend the superior Wi-Fi signal by Repeater setting function under the Wireless column to increase the coverage of the wireless signal.
This document applies to: A800R, A810R, A830R, A3100R, T10, A950RG, A3000RU
Diagram
Preparation
● Before configuration, make sure that both A Router and B Router are powered on.
● make sure you know the SSID and password for A router
● 2.4G and 5G, you can only choose one for Repeater
● move the B router closer to the A router to find the B routing signals better for fast repeater.
Set up steps
STEP-1 B-Router Wireless Setup
You need to enter the settings page of the router B, then follow the steps illustrated.
①Set 2.4G network ->②Set 5G network ->③Click the Apply button
STEP-2 B-Router Repeater Setup
Enter the Advanced Setup page of the router B, then follow the steps illustrated.
①Click Operation Mode>②Select Repeater Mode->③Click Next button
④In next page, you should click Scan 2.4G or Scan 5G
⑤Choose the A-Router SSID you need to make the Repeater
Note: This article set to A router as an example
⑥Enter the password for the Repeater router
STEP-3 B Router Position Display
Move the Router B to a different location for a best Wi-Fi access.
FAQ Common problem
Q1: How to log in to the management page in Repeater mode?
1. Assigned manually IP address 192.168.0.x （“x” range from 2 to 253）, the Subnet Mask is 255.255.255.0 and Gateway is 192.168.0.1.
Note: Default gateway is 192.168.0.1.
1. Enter 192.168.0.1 into the address bar of your browser. Log in the settings interface.
