Application introduction
If you want to login to CP900’s setting interface to configure some settings, please follow the steps below.
It is suitable for: CP900_V1
STEP-1:
1-1. Connect your computer to the router by cable or wireless
1-2. Setup you PC to get the IP automatically (Here I take system W10 for example)
1-3. Click on at the bottom right corner on the screen
1-4. Click [Properties] button in the lower left corner
1-5. Double click on “Internet Protocol (TCP/IP)”.
STEP-2:
Now you have two ways to configure the TCP/IP protocol below
2-1. Use the first default IP address 192.168.0.254:
Assigned manually IP address 192.168.0.x (“x” range from 2 to 253), the Subnet Mask is 255.255.255.0 and Gateway is 192.168.0.254.
Enter 192.168.0.254 into the address bar of your browser. Log in the settings interface.
[Note]:
192.168.0.254 can only be used in AP mode and WISP mode; Client mode and Repeater mode please use his second IP address 169.254.0.254.
2-2. Use the second IP address 169.254.0.254:
Assigned manually IP address 169.254.0.x (“x” range from 2 to 253), the Subnet Mask is 255.255.255.0 and Gateway is 169.254.0.254.
Enter 169.254.0.254 into the address bar of your browser. Log in the settings interface.
[Note]:
169.254.0.254 supports login in Client mode, Repeater mode, AP mode and WISP mode.
STEP-3:
After the setup is successful, your computer must choose to obtain an IP address automatically to access the network. As the picture shows.